[教學] Wii 拆機教學

You will only need two tools to take apartthe Wii. The first is a small Phillips screw driver, which should beeasy to locate. The second tool you will need is a Triwing driver. Thistype of driver is not very common and might take some phone calls orinternet searches to locate. Ours was purchased off of Ebay severalmonths ago to repair a broken Gameboy.
To disassemble:

• Flip the device upside down and remove the small silver Phillips screw. Once out, remove the battery tray from the console.
• Nextremove the rubber foot directly above this battery tray. Also removethe three square white stickers from the bottom of the Wii. The rubberfoot and the sticker are covering hidden screws. Figure 3 provides ashot of where these screws are located. NOTE
  Hidingscrews under stickers and rubber pads is a common method used byelectronics manufactures to help increase the aesthetics of theirdevices, as well as prevent people from easily locating screws andtaking apart their products.
  
  
• Unscrew the two Triwing screws and three Phillips screws from the bottom of the Wii.
  Figure 3
  
  
• Bottom Screws
  
  
• Flipthe Wii over onto its right side. Locate and remove the two rear rubberfeet and the two rectangle stickers near the faceplate.
• Remove the two silver Triwing screws in the holes and remove the two black Triwing screws on the faceplate (Figure 4). Figure 4
  Left side screw locations
  
  
• Flip the Wii upright and carefully remove the two socket covers. They come right out with a little wiggling.
• Removethe three black Phillips screws from the black plate (Figure 5). Notethe one closest to the faceplate is the longest and will need to goback into that hole when putting the Wii back together. Figure 5
  Top black plate screw locations
  
  
• Withthe screws removed, carefully pull off the faceplate of the front ofthe Wii. You will need to disconnect the red/black wire plug from theWii to remove the faceplate completely. Figure 6 shows what is hidingunder the faceplate. Figure 6
  Under the Wii faceplate
  
  
• Remove black plate from memory/controller socket area.
• Remove two silver Phillips and two silver Triwing screws from memory/controller socket area (Figure 7). Figure 7
  Topside screw locations
  
  g
• Laythe Wii on left side (with the ATI and Nintendo logo facing you) andslowly work the right side cover of the console off the device. Thiswill take a little bit of force. If something appears to be stuck,double check to ensure you removed all the screws.
• Locate andremove four screws holding DVD reader in place. Two are located inplain site in the middle of the unit. Two are located near the front ofthe Wii inside the DVD unit (Figure 8). Figure 8
  The insides of the Wii
  
  
• Slowlytilt the DVD player upward toward top of Wii. There are two wires thatneed to be disconnected before you can safely remove the DVD unit. Oneis a plug type of connector that only requires a little tug. The otheris a circuit strip connector that requires you to lift the brown catch,which will release the pressure holding the strip in place (Figure 9).Do not break this! Figure 9
  
  
• You can then access the Installation Canvas and proceed with your Wii Modification